User's Manual

1312
FINE TUNING YOUR SYSTEM
The Wireless VGA Video Sender usually works best with the flat faces
of the antennas on the Sender and Receiver units facing each other
(see diagram below). Sometimes, however, reflections and other
effects in your home may affect the signal so that some adjustment of
either the Sender or Receiver antenna might be necessary to get the
best the signal.
TROUBLESHOOTING
IF YOU ARE NOT GETTING ANY AUDIO OR VIDEO AT ALL FROM THE
VR30A
• Check that the CHANNEL slide switch (labeled A, B, C, D) on both
units is set to the same letter.
• Check that both the transmitter and receiver's power supplies are
plugged in. Check that the ON/OFF switch on the transmitter and
receiver are ON.
IF THE SOUND OR VIDEO IS POOR, OR THERE IS INTERFERENCE
• Try changing the channel on both units. Do this by adjusting the
CHANNEL slide switch on each unit to any position (A, B, C, or
D).
• Make sure both units are set to the same letter. Try repositioning
the antenna on each unit.