VGA Video Sender OWNER'S MANUAL MODEL VK60A (INCLUDES VT36A SENDER VR30A AND VR30A RECEIVER) VT36A
INTRODUCTION Your Wireless Big Picture VGA Video Sender kit consists of a Sender base unit which connects to the audio out jack and the VGA output on your PC, and a Receiver unit which you connect to your TV. The Sender converts the audio signal from your PC's sound card, and the VGA video from your PC's video card into a radio frequency (RF) signal and transmits it (even through walls) to the Receiver unit. The Receiver converts the signals back to their original form and passes them to your TV.
CONTENTS CONTROLS AND CONNECTIONS ................................................. 5 SENDER .......................................................................... 6 RECEIVER ........................................................................ 7 BEFORE YOU START ................................................................. 8 CONNECTING UP .................................................................. 9 HOOKING UP THE SENDER ....................................................
SENDER RECEIVER 310 MHz Antenna for use with UR81A remote 2.4 GHz Video Antenna 2.4 GHz Video Antenna 2.4 GHz Channel Switch TV Output Connector Audio Input Jacks ON-OFF ON-OFF Switch Switch (on side) (on side) Power Supply Jack Power Supply Jack TV Channel Switch A/V Input Jacks (on bottom) Serial port connector 6 2.
CONNECTING UP BEFORE YOU START Before you start installing your Big Picture System it is recommended that you read this entire owner's manual. This will familiarize you with the basic hardware installation. Then install the hardware. You will then be able to see a picture from your PC on our TV screen. You can then visit www.x10.com/software and download the "Boom" program there, which will give you control over what is sent from your PC to your TV. HOOKING UP THE VGA S ENDER 1.
HOOKING UP THE AUDIO RECEIVER 1. Connect a set of Audio/Video cables to the A/V OUT jacks of your Video Receiver. Connect the other end to your secondary TV. IF YOUR SECOND TV OTHER A/V DEVICE IS ALREADY HOOKED UP TO A If your DBS Receiver or other A/V component is connected to the TV using A/V cables, you can connect the Video Receiver to the free LINE IN jacks on the component. If there are no LINE IN jacks, you will need to use a TV antenna splitter as described earlier. 2.
FINE TUNING YOUR SYSTEM The Wireless VGA Video Sender usually works best with the flat faces of the antennas on the Sender and Receiver units facing each other (see diagram below). Sometimes, however, reflections and other effects in your home may affect the signal so that some adjustment of either the Sender or Receiver antenna might be necessary to get the best the signal.
NOTES 12 MONTH LIMITED WARRANTY X10.COM A DIV. OF X10 WIRELESS TECHNOLOGY, INC. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. IF SERVICE IS REQUIRED UNDER THIS WARRANTY: 1. CALL 1-800-675-3044, OR VISIT WWW.X10.COM, OR E-MAIL SALES@X10.
X10.com, a division of X10 Wireless Technology, Inc. (Returns Depot), 3824 North 5th St.
