User's Manual

Setting up the Remote
1.Push the tab and lift off the
battery cover.
2.Fit four AAA batteries, taking
care to match the + and -
marks in the battery com-
partment.
Battery Saver
Your remote automatically “times-out”
if the keys are pressed for more than
two minutes. This will save your batter-
ies should your remote get stuck in a
place where the keys remain
depressed (e.g., between the sofa
cushions).
Code Saver (Important)
You have up to 90 seconds to change
the batteries in your remote without
losing codes you have programmed.
However, do not press any buttons until
batteries are installed in the remote. If
buttons are pressed without batteries
in the remote, all codes will be lost.
Setting up the Receiver
You must install BOOM Software before
connecting the receiver to your PC.
Plug the cord on the receiver into the
USB port on your PC. Locate the
receiver as far away from your PC and
your monitor as its cord allows. The red
LED power indicator on the receiver
should be on.
4
97685 manual 6/12/03.QK 6/12/03 4:48 PM Page 7