User's Manual

1312
I DENTIFYING C ODES FOUND USING
THE
S EARCH P ROCEDURE
1. Press and hold the
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2. Press the mode
button that matches
the equipment you
want to identify.
The LED blinks
once.
3. Press and release
SETUP. The LED
blinks once.
4. To find the first digit,
press each number
button from 0 to 9
until the LED blinks.
The number you
pressed is the first
digit of the code.
5. Press each number
button from 0 to 9
again as above to
find the second and
third digits.
6. Press each number
button in turn to
find the fourth digit.
When the fourth
digit has been
found, the LED goes
out.
S EARCHING F OR C ODES
1. Turn on the device
you want to
control.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Press the mode
button that matches
the equipment you
want to control.
The LED blinks
once.
4. Press CHANNEL +
repeatedly (note 5,
page 11) until the
device to be
controlled changes
channel.
If you accidentally
go past the code,
press CHANNEL -
repeatedly until the
channel changes
again.
5. Press and release
the ENTER button to
complete the setup.
The above assumes that you want to store
VCR codes under the VCR key, Cable
codes under CBL, etc. If you want to
store a VCR code under SAT, etc., first
follow the procedure on page 11 and try
ANY SAT code from the code tables, e.g.
press SAT in step 3, page 10, and then
enter ANY VCR code. Then follow the
steps above.