User's Manual

1918
C HANGING THE X10 H OUSE
C ODE :
The X10 Platinum Remote defaults to
House Code A, and in most cases you
will not need to change this unless you
are experiencing interference from a
neighboring X10 system.
1. Press and release
the X10 button.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Use the number
buttons to enter the
number equivalent
to the chosen
House Code
(1=A, 2=B ..16=P).
4. Press the ENTER
button to confirm
the House Code.
The LED turns off.
Note: The House Code you choose must
match the House Code on the Transceiver
and Modules you are using it with.
CONTROLLING
X10 MODULES
If you have purchased and installed a
Transceiver Module, you can control it
and other X10 modules as follows:
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
‘0’ first for a single
digit number.)
3. Press the appro-
priate button for
the function you
require (see
below).
X10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright: VOLUME +
Dim: VOLUME –
All Lamps On: POWER
All Modules Off: MUTE
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
1. Press and release
the X10 button.