User's Manual

1110
POWER
R
G
ID
FREEZE
AUDIO
SEARCH
CALLER
Y
B
TV/VIDEO
INPUT
OK/I
TV
DVD
AUX
GUI DE
EXITMENU
SET
DIRECTV
INFO
VCR
Direct Code Entry
1. Press and hold the SET button until the red indicator
stays on, then release the SET button.
2. Press and release the desired mode button (TV, VCR,
etc.). The red indicator blinks, then stays lit.
3. Enter the 3 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator flashes.
4. With your device on, press CHANNEL UP. If the
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
Code Entry
1.
2.
3.
Write your codes down here for easy reference later.
Type Type stored Code
TV TV
VCR
DirecTV 263
DVD
Advanced Functions, cont.
TV/VCR/INPUT
When in TV mode the TV/VIDEO/INPUT button
performs the INPUT source switch function.
When in a mode that has been programmed for VCR the
TV/VIDEO/INPUT button performs the TV/VCR
antenna switch function.
When in a mode that has been programmed for Cable the
TV/VIDEO/INPUT button performs the A.B switch
function.
When in a mode that has been programmed for SAT the
TV/VIDEO/INPUT button performs the TV/SAT switch
function.
When in a mode that has been programmed for DVD the
TV/VIDEO/INPUT button performs the DVD Setup
function.
TV/VCR and TV/DVD Combo units
Note that for some TV/VCR and TV/DVD combo units
you might need to set up two different buttons to
control both parts of the combo unit. E.G., (referring to
the Direct Code Entry section on the following page)
you might need to set up a code under the TV button to
control the TV part of the combo unit AND a separate
code for the VCR or DVD under any other button you
choose.