User's Manual

LCD Touchscreen Display Time (continued)

2. Release the SETUP key.

3. Press and release the SETUP key. The LED indicator light

blinks to acknowledge the keypress and the Digit Setup

Screen is shown.

4. Press and release a digit key (1-9) to indicate the length of

time you wish the touchscreen to remain on. (The RCU900RF

can only accept the following options: 1=10 seconds; 2=20

seconds; 3=30 seconds, etc.) Ninety seconds is the longest

length of time allowable. The LED indicator blinks to

acknowledge the keypress.

5. Press and release the LCD ENTER key to save the setting.

The touchscreen returns to the Main Setup Screen.

6. The LCD Touchscreen Display Time setting is now complete.

Backlighting

Backlight illumination is only activated when you press the

LIGHT key on the rubber keypad. Pressing the LIGHT key will

also activate the LCD touchscreen display. After you press the

LIGHT key, the light remains on for 30 seconds, or however

long the LCD Touchscreen Display Time is set to, if no other

commands are given.

If a command is entered after the LIGHT key has been pressed,

the illumination continues for a further 30 seconds after the

command is completed. Once the Backlight time has run out,

the Backlight does not re-activate until the LIGHT key is pressed

again. If the Backlight illumination is on, and the LIGHT key is

pressed again, the Backlight turns off.

Master Reset

A Master Reset returns all the RCU900RF defaults back to the

original factory settings. The Master Reset clears all customer-

programmed codes, Learned commands and Smart Macros,

and resets all key labels.

To perform a Master Reset, follow these steps:

1. Press and hold the SETUP key on the rubber keypad until

the LED indicator light remains on and the touchscreen

shows the Main Setup Screen. This process takes

approximately 2-3 seconds.

2. Release the SETUP key.

3. Press and hold the SETUP key for approximately 5

seconds until the LED indicator light turns off.

4. The default reset is now complete and the remote is in

normal TV Mode (screen is blank).

RCA All Power Off Feature

The RCA All Power Off feature is available in all normal

operating modes. If the ON•OFF key on the rubber keypad is

pressed twice consecutively (within two seconds), all RCA

equipment is turned off.