User's Manual

9
English
Selecting 12- or 24-hours time display
Switch cubo to standby mode.1.
Press 2. Menu, the time will ash.
Press one of the 3. Skip buttons until Set-AP appears in the display.
Press 4. Menu again and select with the Skip buttons the desired AM/PM format.
Store the input with 5. Menu.
Setting display screen brightness
Switch on the device.1.
Press the 2. Menu button.
Press one of the skip buttons until you see DISPLAY on the screen.3.
Press the 4. Menu button again, then use the Volume button to select the desired brightness.
HIGH, LOW or OFF is displayed on screen.
Save your selection by pressing the 5. Menu button.
Alarm function
The alarm can be set to go off at 2 different times.
Put the device in standby mode, then press one of the two alarm buttons until the time 1.
starts ashing.
Use the volume control to set the hours.2.
Press the SKIP button, then use the volume control to set the minutes. 3.
Save your setting by pressing the corresponding ALARM button. 4.
Next, use the MODE button to select the mode to be triggered by the alarm: FM radio, 5.
CD or buzzer.
If you use FM (radio) as the alarm: press one of the preset radio station buttons (1-6) 6.
to select the desired radio station.
If you use the CD as the alarm: press the SKIP buttons to select the desired track number. 7.
A shortcut to the CD track number can also be selected with the 6 preset radio station
buttons (1-6).
Save your setting by pressing the corresponding ALARM button. 8.
Select the desired volume using the volume control buttons. 9.
Save the alarm mode by pressing the corresponding ALARM button. 10.
To switch the alarm on or off press and hold down the ALARM button for a couple of seconds.
To stop the alarm, press the SNOOZE button.