User's Manual

1716
1.
2.
3.
4.
6.
Code Learning, cont.Code Learning
Tips On Learning
1. Use fresh batteries for both the Learning Remote and the
Original Remote.
2. Perform a Master Clear (see page 19) before learning, then try
learning 2 or 3 commands initially. Then carry out a Master
Clear before completely learning your original remote’s
commands.
3. Place the original remote end-to-end with the Learning Remote
so the IR transmitters on both remotes are directly in line with
each other. Keep the two remotes about one inch away from
each other. For some brands you might need to place the
remotes a bit closer, so some experimentation might be needed.
See troubleshooting on page 22.
4. Keep at least three feet away from incandescent or low-energy
lights when learning.
Note 1: Only learn TV codes under TV mode, VCR codes under
VCR mode, etc.
Note 2: No functions may be stored under SLEEP, LEARN, CODE
SEARCH
, or any Mode button.
Note 3: Some functions from some types of remotes might not be
able to be learned.
Learning Commands
The learning feature allows you to “learn” functions from your
original remote control. For example - you may want to use your
remote to operate the RANDOM PLAY feature from your original
CD remote control. This remote is equipped with an “easy learning”
feature that allows you to “learn” features (such as RANDOM
PLAY
from your original CD remote) by following the steps below,
and on the next page:
1. Press and hold the CODE SEARCH button until the red
indicator turns on, then release the button.
2. Press and release the desired mode button (TV, VCR, etc.), the
red indicator blinks then stays on.
3. Press and release the LEARN button, the red indicator blinks
then stays on.
4. Press and release the Learning Remote button that you want
to teach (e.g. POWER).
5. Point both remotes facing each other by approximately 1 inch
apart (see tips on page 16).
6. Press and hold the Original Remote button (e.g. Power) until
the red indicator blinks once and stays on. If there is a learning
problem, the indicator blinks for three seconds and stays on. If
this happens, repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want to learn.
8. Press and release the
CODE SEARCH button when all desired
remote commands are learned. Code Learning is now complete.
Line up your remotes (that you’re learning from) in front of the
Learning remote, on a hard surface approx. 1 inch apart.