User's Manual

Battery Replacement
Providing the batteries have not already failed, they can be replaced with
fresh batteries without the need to reinstall the remote. After removing the
old batteries fresh batteries must be fitted within 30 seconds to ensure that
the security code is retained.
Gently pry the 2 halves of the Keyfob remotes case apart and install two
CR2016 lithium batteries battery in the compartment (+ facing up). Press the
2 halves of the cabinet back together.
Once the batteries have been replaced, confirm that the remote is still logged
in by arming the system. If it does not arm, the code has been lost and you
will need to proceed as described below.
If the batteries have failed completely, the security code will have been lost.
You will need to reinstall the Keyfob remote following the instructions inside
this booklet.
FCC Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)
THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
NOTE: NO CHANGES OR MODIFICATIONS MAY BE MADE TO THE
UNITS. ANY CHANGES MADE TO THE UNITS WILL VOID THE
USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Please visit: http://www.x10.com/support for additional help and warranty
conditions.
Security Keyfob Remote
Model KR32A
The X10 Supervised Security System Model DS8000 includes a Security Console
with an automatic dialer that calls friends or relatives in the event of a break in. A
battery powered Radio Frequency (RF) Door/Window Sensors and battery powered
RF Motion Detector to trigger the alarm, and an RF Keyfob Remote Control for
arming and disarming the system. All sensors and remotes incorporate random digital
security coding.
The system may be configured with any combination of the following items:
• Up to 16* Wireless Keyfob Security Remotes with arm/disarm and panic
functions, and buttons to control security lights in and around the home.
• Up to 30* magnetic switch operated Wireless Door/Window Sensors.
• Up to 30* Wireless PIR Motion Detectors.
• Optional X10 Home Automation modules such as plug-in lamp and appliance
modules and wired-in replacement wall switches can be added to the system.
The manual for the DS8000 system describes the full installation process for the
security system, and should be referred to as a supplement to this instruction booklet.
*Note: Door/Window Sensors and Motion Detectors may be added in any
combination up to a total of 30, e.g. 15 Door/Window Sensors and 15 Motion
Detectors, or any combination up to a total of 30 . There are also 2 hard wired
inputs, which are zones 31 and 32.
X10 Wireless Technology, Inc. Kent WA 98032