User's Manual
4544
The GE Security System can flash lights on and off when the alarm trips. You connect the
lights you want it to control to X10 and/or GE Lamp Modules, Wall Switch Modules, and
Screw-in Modules (sold separately). The SC13A Security Console acts as a “Transceiver”
and passes commands received from wireless remote controls onto your house wiring, so
you can use X10 wireless remote controls to control the same lights that the Security
System flashes. You can also use X10 remote controls to control Appliance Modules, etc.
The system also sends RF wireless commands to GE wireless modules.
The SC13A Security Console also works with X10 wireless motion detectors, again acting
as a Transceiver, to pass the commands from the motion detectors to the X10 Modules.
Expanding Your System
Intercom Systems
Intercom systems which send voice signals over existing electrical wiring may interfere
with the ability to control X10 Modules from your security system with the intercom in use.
If the intercom system has its own separate wiring it will not cause a problem.
The alarm cause is shown on the display
even after disarming.
To remove, Arm and Disarm from a
remote, or disarm by entering the PIN on
the Console.
If the optional PowerHorn does not trip
when the alarm trips.
• Be sure you set the dials on the
PowerHorn
to the same SECURITY
LIGHT code as set in the Console, see
page 26.
• Plug the PowerHorn
into another outlet
near the Console.
The Motion Detector causes false alarms.
• All brands of motion detectors sense
motion by detecting a change in
temperature, therefore do not place the
detector near any sources of heat such
as over a heating vent or an air
conditioner.
• Do not place in a direct source of
bright light, such as sunlight.
PROBLEM SOLUTION
Troubleshooting
Siren doesn’t sound when the alarm is
tripped.
Check that you didn’t accidentally set the
Console for Silent Alarm (SIREN OFF).
See Options settings on page 26.
If TAMPER appears in the display. Fix the problem (close the battery cover
on the Sensor or the Console, then enter
you PIN.
Jasco Products Company warrants this product to be free from manufacturing defects for
a period of ninety days from the original date of consumer purchase. This warranty is
limited to the repair or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be used with this unit.
This warranty is in lieu of all other warranties express or implied. Some states do not
allow limitations on how long an implied warranty lasts or permit the exclusion or
limitation of incidental or consequential damages, so the above limitations may not apply
to you. This warranty gives you specific rights, and you may also have other rights which
vary from state to state. If unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:
Jasco Products Company
311 N.W. 122nd
Oklahoma City, OK 73114
LIMITED 90 DAY WARRANTY