User's Manual

Transceiver Module

The Transceiver Module (sold separately) receives radio

frequency (RF) commands from the Learning Remote to

operate a lamp or appliance plugged into it. The Transceiver

Module also passes on commands over your house wiring to

control other X10 modules (also sold separately). Note that

unlike the Lamp Module you cannot dim and brighten a lamp

connected to the Transceiver Module.

You should locate the Transceiver Module centrally in the

home for maximum range when controlled by the Learning

Remote.

1. Set the House Code to ‘A.’

2. Plug a lamp or appliance into the

Transceiver Module.

3. Plug the Transceiver Module into a

convenient AC outlet. Fully extend the

antenna.

Lamp Module

The Lamp Module (sold separately) may be used to control any

incandescent lamp rated up to 300W. It is not suitable for other

types of lamp such as fluorescent or energy saving lamps, or

lamps which include a dimmer control.

Caution: Do not connect an appliance such as a coffee pot or

heater to the Lamp Module. It may damage the module and the

appliance and could cause a fire hazard.