24110 Universal Remote Instruction Manual ON-OFF SETUP VCR CH VOL VOL CH TV S LE EP 1 4 7 EN TER TV/VCR INPUT 2 5 8 V.
Table of Contents Introduction ...................................................... 3 Button Functions ............................................... 4 Initial Setup ...................................................... 6 Battery Installation ....................................... 6 Battery Saver ............................................... 6 Code Saver ................................................. 6 Power-On default ........................................ 6 Code Setup .........................
Button Functions, cont. Button Functions 1. 23. 2. 22. 3. 21. 4. 20. 5. 19. 6. 18. 7. 17. 8. 16. 9. 15. 10. 14. 11. 13. 12. Note: The Record button must be pressed TWICE to record from your VCR. For some brands of VCRs, you might need to press the Record button once, then press it again for three seconds. Some buttons on the remote might have functions that are referred to by different names on the device you are controlling. E.g., PREV.
Setup Battery Installation The 24110 Remote requires batteries for both the remote and the remote base. Do the following to install the batteries. 1. Push down on the tab on the back of the remote, and lift the cover off. 2. Match the batteries to the + and - marks inside the battery case, then insert 2 AAA alkaline batteries. 3. Press the battery cover back into place. 4. Open the battery door on the bottom of the base. 5.
Code Search, cont. Most users will store VCR codes under the VCR button, DVD codes under DVD, etc. If (for example) you want to store a VCR code under DVD, first follow the procedure for Direct Code Entry (previous page), and press DVD in step 2 of Direct Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry. Then follow the steps for Code Search on the previous page. Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or ON-OFF instead.
Setup, cont. Setup, cont. Controlling Devices Requiring Separate Power On and Off Buttons, cont. To turn the TV off, press and release the ON-OFF button to transmit the Power Off button command. This method can be applied similarly to any device and is available for all Modes. Note this feature is not supported by all codes. Any Mode chosen for Volume/Mute control MUST have its own Volume/Mute function or the Volume/Mute buttons will do nothing.
Sleep Timer Troubleshooting The SLEEP button enables the remote to turn off your TV after a period of 1 to 99 minutes as shown below. The remote must be in TV mode to set a Sleep Timer. This feature works even if your TV does not have a sleep feature. 1. Press and release the TV device button. 2. Press and hold the SLEEP button until the red indicator remains lit (about 2-3 seconds). 3. Release the SLEEP button. 4. Press and release the numeric buttons (01-99) for the time required.
90 Day Limited Warranty FCC Caution THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
24110 Universal Remote Instruction Manual Jasco Products Company 10 E.