User Guide

Power up the Display Table. Ensure the tablet has a charged
battery or is connected to the DC power supply.
Connect the cable’s 16-pin adapter to the vehicle’s DLC,
which is generally located under the vehicle dash.
Connect the main cable V2.0 to the Vehicle Data Connector
on the VCMI unit, and tighten the thumb screws.
Select one of the three methods shown below‚ Bluetooth,
Wi-Fi or USB cable V2, to connect the Display Tablet with
the VCMI device and establish a communication link. Use
only the USB cable connection when programming.
When the VCMI device is properly connected to the vehicle
and the Display Tablet, the VCMI status button on the
bottom bar on the screen shows a green mark, indicating
the system is ready to start vehicle diagnosis.
USB
Wi-Fi
OR
OR
The Measurement application enables testing of electrical
wiring, circuits, and systems.
6
Thank you for purchasing AUTEL MaxiSys MS919. Autel manufactures its tools to the highest standards. If properly maintained and used
according to instructions, the MS919 will provide years of trouble-free use.
The MaxiFlash VCMI is compatible with Autel main cable V2.0 and USB cable V2 only.
Before operating or maintaining this unit, please read these instructions carefully, paying extra attention to the
safety warnings and precautions. Use this unit correctly and with care. Failure to do so may cause damage and/or personal
injury and will void the limited product warranty.