Full Product Manual

1) Tap Steering Angle Sensor Calibration from the SAS function menu

to enter the function screen.

2) Follow the on-screen instructions to set the ignition on/off as guided. The

vehicle battery voltage signal should be in the range 12.5 – 13.5 volts to

proceed with this service, otherwise the scan tablet will display a warning

message.

3) Ensure the steering wheel is in the central position and the front wheels

are in the straight position. Then tap OK to proceed.

4) When the operation is finished, the scan tool will display a confirmation

message. An error message will display if the procedure cannot be

completed. Exit the diagnosis program, and solve the error before

attempting SAS calibration again.

Figure 6-19 Sample SAS Function Screen 1

Figure 6-20 Sample SAS Function Screen 2