Full Product Manual

96
[2] Reset Adjustment to 100%
Once [2] is pressed, the tool will automatically reset the value to 100%.
[3]/[4] Store Data and Exit
When the injection volume adjustment is completed, select [3] and OK to
store the new value in the control units; or, select [4] and OK to retain the old
value.
Injector Rate Adjustment
This function is used to adjust the injector rate for individual cylinders.
1. Tap Injection rate adjustment from the service functions menu.
2. The tool communicates with the vehicle and reads the fault codes
memory. Follow the on-screen instructions to finish this procedure.
3. Tap the corresponding number button to enter a new value for each
cylinder.
4. Follow the on-screen instructions to tap on the corresponding number [1]
[2] [3] [4] to enter the new value for the cylinder, restore the old value,
and exit after finishing the function.
Particle Filter Regeneration
This function is used to perform the particle filter regeneration.
1. Tap Particle filter regeneration on the service functions menu.
2. The tool communicates with the vehicle and reads the fault codes
memory. Follow the on-screen instructions to check the prerequisites
before particle filter regeneration, such as the fuel, the time and driving
style.
3. If the prerequisites are met, confirm to proceed as below. Tap Request
to begin a regeneration or End to end the service function and exit.