Full Product Manual

started. Before starting the Component Test, refer to the vehicle service

manual for instructions to stop the test.

1) Use the UP/DOWN scroll button to select Component Test from

Diagnostic Menu and press the OK button (Figure 4-1).

2) Wait for the scan tool to display the Component Test menu.

3) If the test has been initiated by the vehicle, a confirmation message will

be displayed on the screen.

 Some vehicles do not allow scan tools to control vehicle systems or

components. If the vehicle under test does not support the EVAP

Leak Test, the message, “The select mode is not supported” will

display.

Figure 4-25 Sample Component Test Screen 1

Figure 4-26 Sample Component Test Screen 2