Full Product Manual

 If no codes are found, a message will display “No (pending) codes are

stored in the module!” Wait a moment or press any key to return to

previous screen.

NOTE

Permanent Codes function is available only for vehicles supporting the CAN

protocols.

3) View DTCs and their definitions on screen.

4) If more than one DTC is found, use the LEFT/RIGHT scroll button to

view each code.

 If retrieved DTCs contain any manufacturer specific or enhanced

codes, the tool’s AutoVIN technology will automatically display the

definition of the code.

Erase Codes

NOTE

1. Erasing the Diagnostic Trouble Codes may allow the scan tool to delete

not only the codes from the vehicle’s on-board computer, but also

“Freeze Frame” data and manufacturer-specific enhanced data.

Furthermore, the I/M Readiness Monitor Status for all vehicle monitors

is reset to Not Ready or Not Complete status. Do not erase the codes

before repairs or services have been performed.

2. Even if deleted, codes will again display if the underlining fault causing

the code is not addressed.

3. This function is performed with key on engine off (KOEO). Do not start

the engine.

1) Use the UP/DOWN scroll buttons to select Erase Codes from

Diagnostics Menu and press the OK button (Figure 4-1).

2) A warning message displays for you to check the ignition and engine

status.