Full Product Manual

 If the manufacturer of your vehicle is not listed, use the UP/DOWN

scroll button to select Other and press the OK button.

Erase Codes

NOTE

1) Erasing the Diagnostic Trouble Codes may allow the scan tool to

delete not only the codes from the vehicle’s on-board computer, but

also “Freeze Frame” data and manufacturer-specific enhanced data.

Further, the I/M Readiness Monitor Status for all vehicle monitors is

reset to Not Ready or Not Complete status. Do not erase the codes

before repairs or services have been performed.

2) Even if deleted, codes will again display if the underlining fault causing

the code is not addressed.

 This function is performed with key on, engine off (KOEO). Do not start

the engine.

1) Use the UP/DOWN scroll buttons to select Erase Codes from

Diagnostics Menu and press the OK button.

2) After you have pressed OK button, a message will display asking you

to check the ignition and engine status.

 If you do not want to proceed with erasing codes, press ESC

button or select NO to exit and return to previous screen.

 If you press Yes function key or OK button, a warning message

will come up asking your confirmation.

3) Press the OK button to confirm.

 If the codes are cleared successfully, an “Erase Done!”

confirmation message displays.

 If the codes are not cleared, then an “Erase Failure. Turn Key on

with Engine off!” message displays.

4) Press any button to return to Diagnostic Menu.

Live Data

In this function, you can not only read the live data but also record data for

later review.