Full Product Manual

9
 Verify that the vehicle is OBD II compliant;
 Turn the ignition off and wait for about 10 seconds. Turn the ignition
back on and repeat step 5.
 If the “LINKING ERROR” message continues to display, contact your
local distributor or customer service for assistance.
7) View a summary of system status (MIL status, DTC counts, Monitor
status) on screen. Wait a few seconds or press any key to continue.
Figure 3-2 Sample System Status Screen
 If more than one module is detected, you will be prompted to select
a module before testing.
 Use the UP/DOWN scroll button to select a module and press the
OK button.
8) Then you will be prompted to erase previously stored data.
 Review previously stored data thoroughly before erasing.
Figure 3-3 Sample Erase Previous Data Screen
 If no data is stored in the scan tool, the above prompt will not show
up.
9) If you wish to erase the data, press the OK button; if you do not want to
erase the data, press ESC to exit or use LEFT/RIGHT button to select
NO and press OK for Diagnostic Menu to come up.