Full Product Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support:
- Safety Precautions and Warnings
- 1 General Information
- 2 Using the Scan Tool
- 3 Print and Update
- 4 OBDII Diagnostics
- 5 Ready Test
- 6 Compliance Information
- 7 Warranty and Service
50
Figure 4-36
3) If the test has been initiated by the vehicle, a confirmation message will
be displayed on the screen.
Figure 4-37
Some vehicles do not allow scan tools to control vehicle systems
or components. If the vehicle under test does not support the
EVAP Leak Test, the message, “The select mode is not supported”
will display.
Figure 4-38
4) Wait a few seconds or press any key to return to previous screen.