Full Product Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support:
- Safety Precautions and Warnings
- 1 General Information
- 2 Using the Scan Tool
- 3 Print and Update
- 4 OBDII Diagnostics
- 5 Ready Test
- 6 Compliance Information
- 7 Warranty and Service
37
Figure 4-21
5) Wait for DTC to trigger or press OK to start recording.
Drive till a DTC is detected when DTC Trigger is selected. If no
DTCs are detected, press ESC to exit recording.
Figure 4-22
The number “x/x...” in the upper right corner of the screen
indicates the number of recorded frames out of the maximum
frames that can be recorded
6) The scan tool continues recording PID data until the ESC button is
pressed, selected memory location is full, or it completes recording. A
message will display asking if the recording should be played back.
Figure 4-23