Full Product Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support:
- Safety Precautions and Warnings
- 1 General Information
- 2 Using the Scan Tool
- 3 Print and Update
- 4 OBDII Diagnostics
- 5 Ready Test
- 6 Compliance Information
- 7 Warranty and Service
30
Figure 4-7
If the manufacturer of your vehicle is not listed, use the UP/DOWN
scroll button to select Other and press the OK button.
Erase Codes
NOTE
1. Erasing the Diagnostic Trouble Codes may allow the scan tool to
delete not only the codes from the vehicle’s on-board computer, but
also “Freeze Frame” data and manufacturer-specific enhanced data.
Further, the I/M Readiness Monitor Status for all vehicle monitors is
reset to Not Ready or Not Complete status. Do not erase the codes
before repairs or services have been performed.
2. Even if deleted, codes will again display if the underlining fault causing
the code is not addressed.
This function is performed with key on, engine off (KOEO). Do not start
the engine.
1) Use the UP/DOWN scroll buttons to select Erase Codes from
Diagnostics Menu and press the OK button.
2) A warning message displays for your confirmation.
Figure 4-8