Full Product Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support:
- Safety Precautions and Warnings
- 1 General Information
- 2 Using the Scan Tool
- 3 Print and Update
- 4 OBDII Diagnostics
- 5 Ready Test
- 6 Compliance Information
- 7 Warranty and Service
18
Status Beep Set
The default setting is Beep On.
This function allows you to turn on/off the built-in speaker as an indicator
during diagnostic testing. Different audio tones correspond to different LED
lights. This function is invaluable when performing diagnostics alone, or
while working in bright areas where LED illumination alone is not sufficient.
1) From System Setup screen, use the UP/DOWN scroll button to select
Status Beep Set and press the OK button.
2) From Status Beep Set menu, use the UP/DOWN scroll button to
select Beep ON or Beep OFF to turn on/off the beep.
Figure 2-9
3) Press the OK button to save your selection and return to previous
menu.
Tool Self-test
The Tool Self-test function checks if the display, LED lamps and keyboard
are working properly.
A. Display test
The Display Test function checks if the LCD display is working normally.
1) From System Setup screen, use the UP/DOWN scroll button to select
Tool Self-test, and press the OK button.
2) Select Display Test from Tool Self-test menu and press the OK
button to start test.