Full Product Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support:
- Safety Precautions and Warnings
- 1 General Information
- 2 Using the Scan Tool
- 3 Print and Update
- 4 OBDII Diagnostics
- 5 Ready Test
- 6 Compliance Information
- 7 Warranty and Service
15
Configure Monitors
From System Setup screen, use the UP/DOWN scroll button to select
Configure Monitors, and press the OK button.
Figure 2-6
On this menu, configure the monitors required to test spark ignition and
compression ignition, the number of monitors to pass diagnosis, and
restore the default settings.
A. Spark IGN Required Monitors
From Configure Monitors screen, use the UP/DOWN scroll button to
select Spark IGN Required Monitors, and press the OK button.
The monitors for spark ignition engines display as below:
Table 2-1
Spark IGN Required Monitors
√
MIS
√
EVAP
√
FUEL
√
AIR
√
CCM
√
O2S
√
CAT
√
HTR
√
HCAT
√
EGR
B. Compression IGN Required Monitors