Full Product Manual

35
Use the SCROLL button to select Ready Test from Main Screen, and
press the ENTER/Exit button.
Figure 4-1
As Post-Repair Diagnostic Tool
This function can be used (after the vehicle has done any emission-related
repairs) to confirm that the repair has been performed successfully.
After repairs, some drive cycles are required to reset the monitoring
systems. Drive cycles vary by vehicle and by monitor.
Use the following procedures to check if the repair has been done correctly:
1) Connect the scan tool to the vehicle’s DLC and erase the DTC(s) from
the vehicle’s computer memory.
2) After the erase procedure is performed, status of most monitors will be
changed. Leave the scan tool connected to the vehicle, and select
Ready Test from Main Screen.
3) Continue to drive the vehicle until the scan tool notifies you that the
drive cycle has been completed.
4) If the GREEN LED lights and the tool emits two long beeps, your
vehicle is ready and the repair work is confirmed.
5) If the RED LED lights, your vehicle is not ready and if you have
performed repairs, they have failed to correct the emissions issue.
As Pre-Check Diagnostic Tool
Prior to having a vehicle inspected for state emissions compliance, use this
function to check the readiness status.
1) While the scan tool connected to the vehicle, select Ready Test from
Main Screen. Drive the car till the scan tool notifies you safely with