Full Product Manual

5) Select Previous Menu from the Read Codes screen, and press

ENTER/Exit button to return to previous menu.

Erase Codes

NOTE

1. Erasing the Diagnostic Trouble Codes may allow the scan tool to

delete not only the codes from the vehicle’s on-board computer, but

also “Freeze Frame” data and manufacturer-specific enhanced data.

Further, the I/M Readiness Monitor Status for all vehicle monitors is

reset to Not Ready or Not Complete status. Do not erase the codes

before repairs or services have been performed.

2. Even if deleted, codes will again display if the underlining fault causing

the code is not addressed.

This function is performed with key on, engine off (KOEO). Do not start the

engine.

1) Use the SCROLL button to select Erase Codes from Diagnostics

Menu and press the ENTER/Exit button.

2) A warning message displays for your confirmation.

Figure 3-7

 If you do not want to proceed with erasing codes, use SCROLL

button to select NO to exit. A message of “Command Cancelled!”

displays. Wait a moment or press any key to return to Diagnostic

Menu.

3) Press the ENTER/Exit button to confirm.

 If the codes are cleared successfully, an “Erase Done!”

confirmation message displays.