Full Product Manual

 Turn the ignition off and wait for about 10 seconds. Turn the ignition

back to on and continue the testing.

Scan Tool Doesn’t Power Up

If the scan tool won’t power up or operates incorrectly, do the following:

 Check if the scan tool’s OBD II connector is securely connected to the

vehicle’s DLC;

 Check if the DLC pins are bent or broken. Clean the DLC pins if

necessary.

 Check vehicle battery to make sure it is still good with at least 8.0 volts.

LED Lamps Not Working

If the LED lamps don’t light during I/M Readiness testing, do the following:

 Make sure the OBD II cable is connected to the DLC securely.

 Verify the ignition key is in the KOER position.

 Run the LED Test in the System Setup menu. If the scan tool does not

pass this test, there is a problem with the LED lamp. Please contact

Autel Tech Support or your local selling agent.