Full Product Manual

88
Select one sensor position and place a MX-Sensor near the TPMS antenna
of the tablet (the top right corner), and then tap Copy by Input to program
the new MX-Sensor.
Figure 6-22 Sample Copy by Input Screen
Tap Copy by Input. When the input displays, enter the ID of the original
sensor. Tap the inside of the input box to display a soft keyboard, once
displayed, input the ID and tap Enter when finished.
Sensor either have a hexadecimal format or a decimal format. A warning
message will display if too many characters are entered.
The Copy by Input programming method uses the ID of the original sensor
that is already stored within the TPMS ECU and therefore does not require
the sensor be relearned if the new programmed sensor has been put in the
same position.
Auto Create
The Auto Create function is used to automatically create a random sensor
ID to program a new MX-Sensor.
To use this function, there is no need to activate the original sensor or
retrieve the original sensor IDs from the TPMS ECU.
Select the vehicle model, select a wheel location on the display and place a
MX-Sensor near the top right corner of the tablet. Tap Auto Create to
program the new MX-Sensor.