User Manual

30
2) If the vehicle is equipped with an A/T, ensure that the shift lever is in the
“P” range and the parking brake is applied. If the vehicle is equipped
with an M/T, ensure that the parking brake is applied.
3) Turn the ignition off.
4) Locate the vehicle’s 16-pin Data Link Connector (DLC).
5) Plug the scan tool cable connector into the vehicle’s DLC.
6) Turn the ignition on but do not start the engine.
7) Turn on the scan tool and wait for the Main Screen to appear.
8) Use the UP/DOWN scroll button and LEFT/RIGHT scroll button to
select Service in the Main Screen (Figure 3-2), and then select SAS
from the Service menu.
9) Wait for a series of vehicle identification screens appears to identify the
vehicle. On each screen that appears, use the UP/DOWN scroll button
to select the correct option and then press the OK button. Repeat this
behavior until the vehicle is completely identified.
10) Use the UP/DOWN scroll button to select VGRS in the menu. The
screen displays as below.
Figure 5-10 Sample SAS Function Menu
Read Codes
Please refer to Read Codes on page 71 for details.
Erase Codes