Full Product Manual

72
2) View DTCs and their definitions on screen.
3) If more than one DTC is found, use the UP/DOWN scroll button to check
all the codes.
 If retrieved DTCs contain any manufacturer specific or enhanced
codes, a “Manufacturer specific codes are found! Press any key to
select vehicle make!” message comes up prompting you to select
vehicle manufacturer to view DTC definitions. Use UP/DOWN scroll
button to select manufacturer and then press OK to confirm.
 If the manufacturer of your vehicle is not listed, use the UP/DOWN
scroll button to select Other and press OK.
Erase Codes
Erase Codes is performed with key on engine off (KOEO). This function is
used to delete diagnostic trouble code when the fault the caused the specific
DTC is fixed.
 To erase codes
1) Use the UP/DOWN scroll buttons to select Erase Codes from
Diagnostics Menu and press OK.
2) After you have pressed OK button, a message will come up asking you
to check the ignition and engine status.
 If you do not want to proceed with erasing codes, press ESC button
or select NO to exit and return to the previous screen.
 If you press Yes or OK, a warning message will come up asking
your confirmation. Press the OK button to confirm.
 If the codes are cleared successfully, an “Erase Done!”
confirmation message will appear on the display.
 If the codes are not cleared, then an “Erase Failure. Turn Key on
with Engine off!” message appears.
3) Press any button to return to Diagnostic Menu.
Live Data
In this function, you can not only read the live data but also record data for
later review.