Full Product Manual

iii
Safety Instructions
To prevent personal injury or damage to vehicles and/or the scan tool, read
this instruction manual first and observe the following safety precautions at a
minimum whenever working on a vehicle:
 Perform diagnosis or service in a safe environment.
 Wear safety eye protection that meets ANSI standards.
 Keep clothing, hair, hands, tools, test equipment, etc. away from all
moving or hot engine parts.
 Operate the vehicle in a well-ventilated work area: Exhaust gases are
poisonous.
 Put blocks in front of the drive wheels and never leave the vehicle
unattended while running tests.
 Use extreme caution when working around the ignition coil, distributor
cap, ignition wires and spark plugs. These components create
hazardous voltages when the engine is running.
 Keep a fire extinguisher suitable for gasoline/chemical/electrical fires
nearby.
 Put the transmission in PARK (for automatic transmission) or NEUTRAL
(for manual transmission) and make sure the parking brake is engaged.
 Don’t connect or disconnect any test equipment while the ignition is on
or the engine is running.
 Keep the scan tool dry, clean, free from oil/water or grease. Use a mild
detergent on a clean cloth to clean the outside of the scan tool, when
necessary.
 Avoid electrostatic interference during operation. If a failure occurs due
to electrostatic interference, Please try to operate again.
 Refer to the user’s manual for the vehicle being serviced and adhere to
all diagnostic procedures and precautions. Otherwise personal injury or
unneeded repairs may result.