User Manual

TPMS Service Operations Programming Operations
63
 To copy by OBD
1. After performing Read IDs from Vehicle in Relearn function,
OBD marks with the sensor IDs will appear on the table in
Programming screen.
2. Select the specific wheel on the screen, and then tap Copy by
OBD button.
3. Place the proper MX-Sensor near the top right of the Display
Tablet, and tap OK to start programming the saved sensor
information to the MX-Sensor.
4. The programmed sensor ID will appear on Column 2 of the table.
NOTE: If you have performed both Check and Read IDs from Vehicle
functions, you can select either Copy by Activation or Copy by OBD to
program the retrieved sensor ID to the MX-Sensor.
5.3.3 Auto Create
This function is designed to program the MX-Sensor by applying random IDs
created according to the test vehicle, when it is unable to obtain the original
sensor ID.
 To Auto Create
1. Tap Programming tab.
2. Select the specific wheel on the screen.
3. Tap the Auto Create functional button on the screen.
4. A message with sensor ID will prompt. Place the proper MX-Sensor near
the top right of the Display Tablet and tap OK to write the new created
sensor ID into the MX-Sensor.
After programming is finished, the new programmed MX-Sensor ID will
display on Column 2 of the table.
NOTE: For some models, it is necessary to perform Relearn procedure after
installing the new MX-Sensor programmed by the way of Auto Create.