Operation Manual

3
③ Rubber Boot - protects the scan tool from accidental damage if
dropped.
④ Stylus Pen - selects items and enters information.
⑤ Stand - flips out for setting the scan tool in an upright position.
⑥ External DC Power Port - connects the 12 volt power adapter to
power the tool for updating, printing, Internet access, and etc. when
disconnected from the vehicle.
⑦ USB (universal serial bus) Port - connects peripheral devices such as
printers, and portable USB Drives.
⑧ DB15-Pin Port - connects the vehicle DLC cable.
⑨ RS 232 Serial Port - connects the PC serial cable.
⑩ On/Off Button - turns the scan tool on and off.
NOTE: No internal battery power is provided with this scan tool.
⑪ SD Card Slot - holds the System SD Card.
NOTE: Do not remove memory card from the scan tool unless
performing software updates to card.
1.2.2. Memory Card
Figure 1.5: Memory Card into Scan Tool Slot
The memory card contains the scan tool’s operating software and
applications (DO NOT REMOVE THE MEMORY CARD UNLESS
PERFORMING SOFTWARE UPDATES TO CARD).