Product Specs

Assemble the Center Camera

1. Adjust the four T hammer nuts (M6) attached on the center camera to the horizontal

direction, and insert all the T hammer nuts (M6) into the first and second slide slots

of the crossbar next to the pattern board slot.

Figure 3-8 Adjust the Nuts

1. Tighten the bolts with the hex L-wrench until the camera is secured.

Figure 3-9 Tighten the Bolts

1. Plug the connector of the short power supply cable into the power input port at the

bottom, and plug the connector of the short signal cable into the USB C port.

2. Insert the two cables (short power supply cable and short signal cable) into the fourth

slide slot of the crossbar. Press the sealing strip into the slide slot and ensure it is

flush with the crossbar.