Users Manual

1、 turn on the power of the station;
2、 turn on the remote control and run the Autel Voyager App, select "Settings ->
Base Station", you can see the base station wifi hotspot after entering, enter the
password: 12345678, wait a few seconds until the remote control is successfully
connected to the base station;;
3、 exit Setting interface, enter the mission flight interface, click the gear icon in the
upper right corner, enter the settings menu, click "remote control", and turn on
the "use base station connection" option.
Link the ground station and the aircraft
1、 Press (short press) thebutton in the battery compartment of the aircraft to enter
the state;
2、 linkingopen the remote control and run the Autel Voyager App to enter the
mission flight interface, and click the gear icon in the upper right corner , Enter the
setting menu, click "remote control -> data and video linking -> start linking", wait
a few seconds until linking is successful.
Description of thetransmission status indicator:
videoGreen 1.5s/1.5s blinking slowly:transmission is not connected,
green light 0.1s/0.1s blinking fast:
videovideo transmission is linking,light 0.1s/2.0s blinking: video transmission is
normally connected,
greengreen light 3s /0.2s flashing on and off: Upgrade download data installed during
Green light on: firmware upgrade
Dragon Fish GNSS base station is
Choose a place with a wide view to set up the Dragon Fish GNSS base station and
mark it (align the center of the tripod with the center of the mark point) so that the
base station can be accurately reset after being moved.
1. Open the tripod, stretch the three telescopic rods to a suitable length, and then
tighten the knob to ensure that the tripod is stable.