Application Guide

Figure 2.8
This shows that the vehicle integration level is newer than the one stored in MaxiSys
Pro, and programming function is not recommended.
MaxiSys Pro will then read related information from each control unit to confirm
whether it needs to be replaced or upgraded. After that CIP Main Interface will be
shown. Please refer to 2.3 CIP Main Interface for detailed information.
2.2 Re-entering CIP
If CIP function has been performed before on the vehicle, MaxiSys Pro can save the
previous session which records the configuration information. When MaxiSys Pro
re-enters CIP, a prompt message will pop up to confirm whether to use the saved
session, as shown in figure 2.9.