User Manual

35
1. Tap Erase Codes from the Function Menu.
2. A warning message displays to advise of data loss if this function is
completed.
a) Tap Yes to continue. A confirming screen displays when the
operation is successfully done.
b) Tap No to exit.
3. Tap ESC on the confirming screen to exit Erase Codes.
4. Perform the Read Codes function again to check if codes have
been erased successfully.
Live Data
When this function is selected, the screen displays the data list for the
selected module. The items available for any control module vary by
vehicle. The parameters display in the order that they are transmitted by
the ECM, so expect variation between vehicles.
Gesture scrolling allows for quick movement through data list. Using one
or two fingers, simply swipe the screen up or down to locate the data you
want. The figure below shows a typical Live Data screen:
Figure 4- 13 Sample Live Data Screen
1. Diagnostics Toolbar Buttons – tap the drop-down button at the top
center of the screen and the toolbar buttons will display. See on Table
4- 2 Diagnostics Toolbar Buttons page 27 for detailed descriptions of
the operations for each button.
2. Main Section