Operation Manual

Mode $06 - Non-Continuously Monitored Systems test results. There are

typically a minimum value, a maximum value, and a current value for each non-

continuous monitor. This data is optional, and it is defined by a given vehicle maker

if it’s used.

Mode $07 - Request for DTCs (pending) from Continuously Monitored

Systems after a single driving cycle has been performed to determine if

repair has fixed a problem. This is used by service technicians to verify repair

was performed properly and after clearing diagnostic trouble codes.

Mode $08 - This Special Control Mode requests control of the on-board

system, test, or component bi-directionally (where applicable). This mode is

manufacturer specific.

Mode $09 - Reports vehicle information. This information includes vehicle VIN

number and calibration information stored in the vehicle ECUs.

* With on-screen graphing

Table 1: Comparison of AutoLink Tool Capabilities

Mode

AutoLink

AL309

AutoLink Pro

AL510

Mode 1 *

Mode 2

Mode 3

Mode 4

Mode 5

Mode 6

Mode 7

Mode 8

Mode 9

MS309 Manual_V1.01.fm Page 9 Wednesday, January 7, 2009 2:42 PM