User's Manual

58 59
If the camera is powered off during video recording
• Keep the Micro-SD card inside the camera. Restart the camera and wait until
the video les are recovered (partial data may be lost)
If acquisition of the WiFi SSID fails
• Check if both the aircraft and the remote controller are powered on
• Make sure WiFi is enabled on the mobile device
If the aircraft is out of sight and the video link is lost
• Activate Go Home procedure to have the aircraft automatically return or
activate IOC procedure (Home Lock) to manually navigate it to return
If the mobile app is accidentally closed when the aircraft is executing a
Waypoint mission
• If the app is closed when the ight mission is under execution, the aircraft will
continue to execute the given command
• You can regain control of the aircraft with the remote controller manually at
any time
Storage and Maintenance Instructions
To ensure optimum performance of the product, we advise you read and follow
the maintenance instructions in this section carefully.
• Keep the devices in a clean, dry and ventilated environment within normal
operating temperatures.
• Keep the devices out of sunlight when not in use
• Dry your hands before using the devices.
• Use a soft cloth with alcohol or a mild window cleaner to clean the lens of the
camera, instead of any abrasive cleansers, detergent or chemicals.
• Ensure that the battery charger does not come in contact with conductive
material.
• Avoid dropping your devices, especially on a hard surface. Check it in detail
after any crash or impact, and contact a local Autel Robotics agent in time if
you have any problem.
• Only use the battery chargers or other accessories authorized by Autel
Robotics. Failure to do so may void the warranty.
Customer Service
This section contains information regarding technical support, repair service, and
NOTE
• The upgrade process lasts about 30 minutes. Do not turn off any device
or take out your SD card from the camera during the process. Do not
start the motors.
• After the upgrade is completed, the remote controller may be
disconnected from the aircraft, and you will need to rebind the devices.
Troubleshooting Tips
Should you have any issues operating the product, read this section for possible
solutions.
When the aircraft indicates failure during self-check (with 4 LED lights ashing
quickly in red and the buzzers beep continuously)
• Hardware proplems detected and you need to contact the Customer Service
When the aircraft motors fail to start up
• Check if the remote controller and the aircraft are properly bound
• Check if the remote controller is properly calibrated
• Check if the battery level is below 15%
• Check if the compass is experiencing interference
• Make sure the Flight Mode Switch is not in the GPS position if the GPS
signal is not strong enough
• Make sure GPS is available when Beginner Mode is activated
When take-off fails after motors start
• Check if the aircraft is in a no-y zone
• Make sure the aircraft is placed on a at, leveled surface
When the aircraft’s ight time reduces
• This is possibly due to low temperature of the operating environment or
increased take-off weight
When pairing up, the aircraft does not respond to the remote controller
• Make sure there are no metal objects, wireless sources or other remote
controllers around
If Video link fails or disconnects frequently
• Make sure your aircraft and remote controller are free from all magnetic or
signal interferences