User's Manual
48 49
3. Set a safe altitude for the aircraft to perform Go Home at low battery
level.
4. When the aircraft is performing a Waypoint mission, you may adjust
the aircraft's speed with the right command stick and command its
nose to face next waypoint with the Face Next Waypoint button. The
Exit button is used to exit this mode. Tapping ( ) on the upper right
corner will save the current route into Favourites.
TIPS
To terminate the Waypoint mission at any point, perform one
of the following actions:
• Regain control of the aircraft by sliding the Flight Mode
Switch on the remote controller to ATTI position. (Only
available when ATTI is enabled on the app) The aircraft will
terminate the mission and respond to the remote controller.
• Press ( ) on the remote controller and hold for 2 seconds.
The aircraft will terminate the mission and land at the home
point.
• Push the Ascent stick to the position of 90% in range and
hold for 2 seconds. This is the same with the method to
regain control of the aircraft during Go Home. ( 32)
• Point on Map - Select Point on Map from the drop-down box of
Waypoint Location and your screen will display the map. Tap on
the map to pin down up to 15 waypoints and they will be linked
automatically as a route. Tapping Delete Waypoint can remove
the last waypoint you pinned down. When you have conrmed all
the waypoints, tap Finish.
NOTE
To edit a selected waypoint before
Finish, tap on the waypoint you wish
to edit and Waypoint Settings will
pop up. You can then set the waypoint
altitude, hover duration, and decide
whether to delete the waypoint.
2. Decide whether the aircraft will Hover or Go Home upon task
completion, and tap Start.