User's Manual

46 47
you have set. You can command the aircraft to y along the route you have
saved in Favorites, or create a new route.
IMPORTANT
For X-Star Premium, you can use this function directly and the map
will be downloaded automatically. For X-Star, if you use the app on an
Android mobile device, you need to download the map before using
this function for the rst time; this is not necessary if you use an iOS
device, as the iOS system allows simultaneous connection with the
aircraft self-generated WiFi network and the 3G/4G network.
¾ To download the map on X-Star
1. Disconnect your mobile device from the X-Star WiFi network.
2. Connect your mobile device to the Internet and enter the map from
Map Split Screen to download the map.
3. Reconnect your mobile device to the X-Star WiFi network and come
back to this function.
¾ To perform Waypoint mode
1. Choose one of the following 3 ways to set up your waypoints.
• Aircraft - Select Aircraft from the drop-down box of Waypoint
Location. Move your aircraft to a target position and tap Mark
Waypoint to set it as one of your waypoints. The rest of your
waypoints can be done in the same manner. The Delete Waypoint
button is used to remove the last waypoint you set. When you
have conrmed all the waypoints, tap Finish.
• Draw on Map - Select Draw on Map from the drop-down box of
Waypoint Location and your screen will be switched to the map.
Move your nger to draw a route on the map, and the waypoints
will be identied automatically according to your route. The Clear
Waypoints button is used to delete the entire route. When you
have conrmed your route, tap Finish.
using the remote controller during Follow mode.
Adjust the altitude of the aircraft.
Change the direction of the aircraft’s
nose.
Adjust the distance between you and
the aircraft.
Command the aircraft to follow you in
a circular course leftward or rightward.
NOTE
• Follow mode is valid within 100 meters radius centering the mobile
device. However, the aircraft will not turn its nose towards the
mobile device when the horizontal distance between them is less
than 3 meters.
• You can choose a location (your current position or the initial home
point) for your aircraft to return to when Failsafe is activated in
Follow mode.
IMPORTANT
• Orbit and Follow modes cannot be activated when the aircraft is
less than 10 meters high above the home point. Once you have
activated Follow or Orbit mode, the altitude limit will be cancelled.
• In Follow or Orbit mode, if the GPS signal of your mobile device
is too weak, the aircraft will switch to hover mode until the GPS
signal quality becomes acceptable again. Follow/Orbit mode will be
cancelled automatically after 15 seconds of poor GPS reception of
the mobile device.
z Waypoint Mode
This mode allows the aircraft to y in a preset route according to the waypoints