User's Manual

28 29
¾ When the motors are turned on, use one of the following methods
to take off the aircraft:
Takeoff/Landing Button: Ascent Stick:
Hold for 2s push gently
If you command the aircraft to take off using , the aircraft will ascend
automatically to a height of 4 meters.
NOTE
can only be activated after 3 seconds upon motor start-up, and does
not work in ATTI Mode.
WARNING
Do not block any of the air vents located beside the motors. Make sure the
motors have cooled down completely before you touch it.
Command Stick Control
The aircraft reacts to the control of the command sticks through the RF
transmission. The ight speed depends on the magnitude of the stick commands.
TIPS
For beginners, it is recommended to move the command sticks lightly and
slowly to keep the aircraft ying in a controllable speed.
z Left Command Stick
A. Ascent/Descent – commands the aircraft to ascend by pushing the stick
upward, and descend by pushing it downward.
Remote Controller and Flight Operations
The remote controller has 2 command sticks designed for convenient remote
ight controls for aerial maneuvers, including aircraft ascent/descent, left/right
rotation, forward/backward and left/right sideway movements.
WARNING
When the GPS signal is not strong enough, the aircraft will not take off in
GPS mode.
For the aircraft to receive maximum signal strength from the controller, position
the two antennas so that they are parallel to each other and that their pointing
direction is perpendicular to the direction of the aircraft’s position, as shown in the
images below.
Motor Start-up and Take-off
Start the motors before commanding the aircraft to take off.
NOTE
The aircraft will not take off if the battery level is 15% or lower.
¾ Start the motors in one of the following ways:
Motor Starter: Both Command Sticks:
Hold for 2s
Hold toe-in or toe-out for 2s