User's Manual

24 25
detects compass deviation, indicating that you should change a place and
calibrate the compass. If a drift occurs when the aircraft is hovering, the compass
calibration is also necessary.
WARNING
The compass is very sensitive to electromagnetic interference that may
cause compass error and poor ight. If you nd the compass abnormal
after calibration, move the aircraft to another location and try again.
Remember to meet the following requirements when carrying out compass
calibration:
• Operate calibration outdoors (ideally on an open space such as a lawn).
• Be free from all magnetic interferences, such as magnetite or steel
reinforcement found in concrete.
• Stay away from both underground and overhead power lines.
• Do not carry ferromagnetic materials (e.g., keys) with you.
¾ To calibrate the compass:
1. Begin calibration with your app: Settings ( ) > Flight Control Settings
( ) > Compass Calibration, and follow the on-screen instructions that
help you monitor the calibration status. When the calibration process has
been initiated, the 4 LEDs on the aircraft will ash yellow light.
2. Hold the aircraft horizontally
and rotate it until the 4 LEDs
on the aircraft change into
ashing green light, indicating
that this step is completed
successfully.
3. Hold the aircraft vertically and
rotate it again with its nose
facing downwards. When
calibration succeeds, the
4 LEDs on the aircraft will
illuminate solid green light for
5s.
Connecting the Mobile Device
The X-Star/X-Star Premium network is established when the aircraft, the remote
controller and the mobile device are properly connected. This enables the mobile
device to receive real-time ight data and video footage during ight so you can
monitor ight maneuvers through the mobile app.
¾ To connect the mobile device to the aircraft
1. Power up the remote controller and the aircraft successively.
2. Connect your mobile device.
X-Star:
Turn on the WiFi connection on your mobile
device, select X-Star_×××××× from the WiFi
list, and enter the default password 99999999.
X-Star Premium:
Use a USB cable to
connect your mobile
device to the USB
Port on the back of the
remote controller.
3. Launch the mobile app ( ) on your mobile device. When the connection
is successful, the Home Page of the app displays Connected in the upper
left corner, and the Flight Information Panel on the remote controller
displays App Connected in the Flight Status Bar.
Calibrating the Compass
Make sure to calibrate the compass every time when ying in a new location.
The rear 2 LEDs on the aircraft will show solid yellow light when the ight system