User's Manual

22 23
NOTE
The remote controller is made to comply with both CE and FCC standards.
The system automatically chooses to comply with CE or FCC standard
depending on the GPS locations.
Preparing the Mobile Device
By connecting your mobile device to the aircraft, the X-Star mobile app Starlink
TM
congures your mobile device to perform as a First Person View (FPV) monitor and
a ground station for remote piloting, ight conguration and waypoint navigation.
The Starlink
TM
app works on both iOS and Android smart phones and tablets. You
can download it from our ofcial website, Google Play or App Store.
Supported systems:
• iOS 8.0 or later (only compatible with iPhone 5 or later iPhone models)
• Android 4.0 or later
Installing the Mobile App – Starlink
TM
Download and install the X-Star/X-Star Premium mobile app Starlink
TM
according
to the following procedures.
¾ To install Starlink
TM
:
A. Search in App Store/Google Play by entering the keyword Starlink (case
insensitive) to download and install the app on your mobile device.
B. Download Starlink
TM
from the ofcial website:
1. Visit http://www.autelrobotics.com
2. Download from Support > Downloads > Software & App
3. Install the mobile app on your mobile device
NOTE
Starlink
TM
will be updated regularly. Please check occasionally for latest
updates.
IMPORTANT
• Check and ensure every propeller is stably mounted and in good
condition before each ight. Do not use aged or damaged propellers.
• Power off the aircraft before installing or removing the propellers.
Keep off the propellers or motors when they are spinning. Remove the
propellers when testing the motors’ operation.
TIPS
It is recommended to remove the propellers when the aircraft is not in use.
Preparing the Remote Controller
¾ To power up the remote controller
Press and hold the button for 2 seconds until it lights up as solid green.
IMPORTANT
It is recommended to power up the remote controller before turning on
the aircraft.
¾ To power off the remote controller
Press and hold the button for 2 seconds until you hear a short beep sound.
NOTE
The remote controller makes an alert sound after 15 minutes of
inactivity, and turns off automatically after 30 minutes of inactivity.
When powering on/off the remote controller, you can check the CE/FCC standard
on the upper left corner as shown below.