User's Manual

20 21
Reinstall the gimbal holder after using the aircraft to protect the gimbal from
unwanted movements when not in use.
Installing Propellers
WARNING
Do not power up the aircraft while installing or removing the propellers.
IMPORTANT
It is recommended to wear protective gloves when assembling or removing
the propellers to protect you from the sharp edges. Use tools (e.g., wrench,
plier, etc.) when necessary.
On each of the propellers there is one Lock icon and one Unlock icon indicating
the rotate direction to fasten or unfasten the propellers.
Fasten the propeller by rotating the propeller
in the indicated direction.
Unfasten the propeller by rotating the
propeller in the indicated direction.
¾ To install the propellers
1. Remove the warning cards from motors after reading. Do not power up
the aircraft.
2. Match two of the
propellers with red nuts
to the corresponding
motors with red paint,
and the other two with
silver/black nuts to the
unpainted motors.
3. Fasten the propeller by rotating in the direction indicated by the icon
printed on the propeller.
¾ To remove the propellers
1. Power off the aircraft.
2. Unfasten the propeller by rotating in the direction indicated by the
icon printed on the propeller.
3. Connect the charger to a power outlet.
● The battery level indicator lights on the aircraft battery will illuminate
and indicate the current battery level during charging, and will turn off
when the battery is fully charged.
Battery Level Indicator Status While Charging
● - Indicates solid green light; ◎ – Indicates ashing green light
● The button on the remote controller will illuminate solid green light
(when RC power on) or solid red light (when RC power off) during
charging. When charging is completed, it is prompted on the Flight
Information Panel, and you will hear two beep sounds.
4. When charging is completed, disconnect the charger and the aircraft
battery/remote controller.
NOTE
For a full charge, the aircraft battery requires 1 hour and the remote
controller requires 4.5 hours approximately.
Preparing the Aircraft
Follow the instructions in this section to prepare the aircraft for a safe ight.
Removing Gimbal Holder
Remove the gimbal holder before powering up the aircraft to avoid damage. Pull
out the attached gimbal holder carefully as illustrated below.