User's Manual

12 13
Flight Information Panel
The LCD Flight Information Panel found on the X-Star/X-Star Premium remote
controller is designed to provide you with intuitive information during the ight,
including the ight status, warning messages, real-time instructions, etc. This
section introduces the function of this panel.
z Remote Controller Calibration
Every time you see Calibrate RC on the Flight Information Panel, please
calibrate the two command sticks and the Gimbal Pitch Dial. You can calibrate
your remote controller according to the following steps, or using the mobile
app instead ( 52).
¾ To calibrate the remote controller
1. Turn off the remote controller, and then
press and hold the ( ) and ( )
buttons simultaneously until the RC
calibration screen appears as shown on
the right. The two crossed bars represent
the left and right command sticks, and
the horizontal bar at the bottom stands
for the Gimbal Pitch Dial.
2. Release both command sticks and the
Gimbal Pitch Dial naturally to the central
position. The three central rounds on the
RC calibration screen will be highlighted
successively.
3. Push both command sticks to the
ends of their 4 directions, and turn
the Gimbal Pitch Dial clockwise and
counterclockwise to its 2 ends, holding
respectively until you hear a beep. All the
bars on the screen will be fully highlighted
when your calibration is completed.
z Binding
The remote controller and the aircraft are bound by default when both devices
are powered up. However, when you change an aircraft or remote controller,
or activate the RC Binding Button on the aircraft, you need to rebind your
aircraft and remote controller.
⑬ Gimbal Pitch Dial
Turn the dial to control the tilt angle of the gimbal.
⑭ Flight Mode Switch
Switch between IOC, GPS and ATTI modes.
⑮ Camera Settings Dial
Turn the dial to adjust the Advanced Camera
Settings. ( 41)
⑯ Playback Button
Playback the captured images or videos. (Only
functions when the remote controller is connected to
the mobile app.)
⑰ Support Stand
Holds up the remote controller at a 40 degree angle.
⑱ Shutter Button
Takes a photo. If burst mode is selected, the set
number of photos will be taken with one press.
⑲ Record Button
Record a video. Press again to stop recording.
⑳ CAN-bus Port
Connects two remote controllers with one operator
as the instructor and the other as the learner. ( 54)
Micro-USB Port Reserved port.
USB Port Connects to a mobile device through a USB cable.