User manual

Table Of Contents

6.7 Flying the Mission

Once onsite, make sure the aircraft is connected, the correct mission loaded, and ready to fly; all that

remains is to tap the button and the flight operation will begin.

The first step will be flight inspection to check the flight status and SD card storage. Once the

inspection is passed, click “FLY” to perform the mission.

There is very little user interaction once the operation begins. The gimbal is positioned and camera

photo shoots are all configured and started automatically.

The aircraft will fly the complete mission as defined. Once completed the aircraft will either Return to

Home or Hover at the Last Waypoint depending on the Finish Action set in the Mission Properties.

6.6 Loading a Saved Mission

All saved missions located on the device appear under the Create New Mission in the Mission History

section. The mission’s save date and a small image representing the mission area are displayed to

assist in located the mission to load.

Missions are displayed in the “most recent saved” order with recently saved missions appearing near

the top and older missions towards the bottom of the list. Scroll through the list until you locate the

desired mission and tap the mission to load it into memory. Once loaded the mission is ready to fly.

You can also edit and/or save the mission under a new name if required.

NOTES:

Only missions for the currently connected aircraft will be displayed. Missions created for the

EVO aircraft are not compatible for use with the EVO II and missions created for EVO II are not

compatible with EVO.