Product Manual
33
Chapter 4
Flight Operations
4.1 Preight Checklist
Follow these steps to carry out a full preight checkup:
• Fully charge the EVO aircraft battery, remote control, and your mobile device
• Remove the gimbal holder
• Make sure the propellers are in proper condition and are correctly attached
• Position the antennas on the remote control so as to get the best possible
transmission quality
• Pair the aircraft and remote control (and your mobile device, if you’re using it)
• Ensure that the rmware has been updated to the latest version
• Make sure you are familiar with the ight controls
• Double-check that your ight area is open and unobstructed
• Check the weather, including air temperature and wind speed
• Check the EVO camera lens and sensors and clean them as needed
4.2 Remote Control & Flight Operations
There are three Command Stick Modes available for the aircraft: Mode 1, Mode
2 and Mode 3. Each one controls the aircraft differently. The diagrams below
employ Mode 2, which is the default. You can change the mode by following to
the instructions in the App Manual.
Basic Flight
1. Place the aircraft in an open, stand at least 5 meters clear of the rear of the
aircraft.
2. Turn on the remote control.
3. Turn on the aircraft and wait for the Rear LED Indicators to ash green
slowly.