Product Manual

32
WARNING
The compass is very sensitive to electromagnetic interference causing
compass error and poor ight. If you nd the compass abnormal after
calibration, move the aircraft to another location and try again.
When calibrating the compass, remember to:
1. Set up in an open outdoor area.
2. Stay clear of all sources of magnetic interference, like magnetite or the steel
reinforcement found in concrete. Proximity to large structures may also result
in reduced calibration.
3. Stay well clear of underground and overhead power lines.
4. Remove all ferromagnetic materials (e.g., keys, magnetic jewelry).
5. Remove electronic devices that might interfere with the calibration (e.g.,
mobile devices, the remote control).
 Calibration Procedure
1. Start the calibration process by pressing the Take-off/Landing Button ( )
and Go Home Button ( ) on the remote control simultaneously for 3
seconds. The Rear LED Indicators on the aircraft will ash yellow when you
initiate the calibration process.
2. Hold the aircraft horizontally and rotate it until
the Rear LED Indicators on the aircraft turn
solid green, indicating this step has been
completed successfully.
3. Hold the aircraft vertically with the nose facing
downward and rotate it until the Rear LED
Indicators on the aircraft turn solid green,
indicating that the calibration is successful.
NOTE
• If the calibration is unsuccessful, the Rear LED Indicators on the aircraft
will illuminate solid red. In this case, repeat the above steps.
• You can also calibrate the compass using the Autel Explorer
TM
app.
Find out how in the App Manual.